Surplus item to be discontinued. 1 Year warranty from JED
3-Way FloVerter Motorized Valve Model:
The FloVerter 12VAC valve works
conjunction with either HelioMatic
electronic controller model.
When the controller is signaled by the sensors, and calls for solar heat
pick-up, the FloVerter valve immediately activates. The opening "diverter" valve
then directs the flow of circulation through the solar collectors using the
pool's filtration pump.
The FloVerter valve is a 12VAC 2" I.D.
valve, utilizes permanent magnetic synchronous motors, and has an
extremely low CV.*
Technical Specifications: The
FloVerter is a non-positive seal
valve with a small hole located
in the diverter, which allows the collector to drain when the system is turned
off. This draining prevents collector
damage due to cold weather freeze-ups.
FloVerter's Unique Features:
• Low profile design utilizes two synchronous motors
to direct flow
using twin O-Rings that provide superior service
• Diverter designed with curved and fluted channel
for reduced pressure
valve/actuator require no assembly; actuator easily replaced
• Manual control over-ride always available using
• Color-coded wire
terminals make connecting to controller a breeze!
• Non-positive seal for freeze protection; positive seal
• The FloVerter never needs
lubrication, and may be mounted in any
position except upside down
Note: For a positive
solar shutdown, or service to collectors during
pump operation cycle, an
isolation ball or gate valve must be used on
the feed line for positive shut
*The extremely low Constant Velocity factor is due to
curved and directed flow channel inside the diverter.
The FloVerter valve is better than ever!
A number of changes have been made to the Flo-Verter valve to make it even
more reliable! Every component of the Flo-Verter valve has been analyzed and
reevaluated. To further enhance the performance of the Flo-Verter, a
number of positive changes have been made.
• The motor mounts of the actuator motors are
now thru bolted.
• The wire terminal splices
are soldered at the factory.
actuator shaft is manufactured to upgrade tolerances with
and sealed with silicone to prevent the build-up
of chlorine gases.
• The Model ‘D’
controllers have a delay module built into the circuitry
block spikes and voltages that might cause the valve to stop part
• way to collection.
How is the Flo-Verter valve different from others?
The Flo-Verter valve looks pleasingly different from other motorized valves
at the plumbing site of the pool. The homeowner can simply observe the
arrow shaped valve handle and determine that pool water flow is going to the
collectors, giving them confidence that solar heat collection is taking place.
There is not a toggle switch on the Flo-Verter valve that can easily be left in
the wrong position thereby eliminating costly service calls. The handle on the
Flo-Verter valve allows the home owner or service personnel to manually change
the direction of water flow. If left in a position not commanded by the
controller, the valve position will be automatically corrected the next
FloVerter Technical Notes: Installation is
simplified as one
port is easily identified with a "FLOW TO COLLECTOR"
An adequate length of three wire color coded cable is
attached to the FloVerter valve and these three wires connect to
color identified terminals on the HelioMatic controller. There is
a need to check flow direction as an error is impossible if the same
colors are connected together.
The FloVerter is a non-positive seal
valve and the diverter has
a small hole, which allows the collector to drain
when the system is off.
This draining prevents collector damage due to
Note: For a positive solar shutdown, or
service to collectors during
pump operation cycle, an isolation ball or gate
valve must be used on
the feed line for positive shut off.
Heliotrope Pool Flo-Verter Valve
HELP » Contact Customer
• Toll-Free help line offering unit selection assistance
Online e-mail technical and installation support
Note: All product performance tests and claims are that of
manufacturer, not The Energy Supermarket.
Processing and Delivery Information: Please allow Processing
Time as stated above for your order, plus standard transportation delivery
time. Orders placed after 2PM EST may not begin processing until the next
business day. Please call for Rush Processing and/or Rush Shipping